Connection status: EHCI:HUB:USB 2.00 High-Speed
Interface: UFI High-Speed
Serial number: 0011-8841-8893
Boot version: 1.05, FW version: 1.13 (Aug 19 2019 23:46:09)
Insertion test... Done
Init bus...
VCC: 3.3 V, VCCQ: 1.8 V
Failed to initialize eMMC (return code: 6, CMD Error: Invalid Voltage Range) !!!
CMD1 error, cmd response: 0x40FF8080, card state: 255 (Card is in unknown state)
SEND_OP_COND command failed.
--- Card might be DEAD, for OLD moviNAND(Samsung) eMMC you may update the firmware with TestPoint ! ---
Check your connection, make sure eMMC inserted properly.


I try another chip
Connection status: EHCI:HUB:USB 2.00 High-Speed
Interface: UFI High-Speed
Serial number: 0011-8841-8893
Boot version: 1.05, FW version: 1.13 (Aug 19 2019 23:46:09)
Insertion test... Done
Init bus...
VCC: 3.3 V, VCCQ: 1.8 V
Failed to initialize eMMC (return code: 17, CMD Error: Timeout) !!!
CMD1 error, cmd response: 0xFF8080, card state: 255 (Card is in unknown state)
SEND_OP_COND command failed.
--- Card might be DEAD, for OLD moviNAND(Samsung) eMMC you may update the firmware with TestPoint ! ---
Check your connection, make sure eMMC inserted properly.


anyone have solution for this





› See More: mi note 6 pro emmc flashing error